The ENNOID XLITE-V3 is a smart BMS.
The setup for the XLITE-V3 is easy. It is reccomended that you plug in your battery first, using the battery’s output plug first followed by the balance leads. NEVER LEAVE THE BALANCE LEADS PLUGGED IN WITHOUT THE OUPUT PLUGGED IN.
Be sure to note that the XLITE uses XT-30s, not XT-60s or XT-90s. With the XLITE plugged into the battery, plug it into your charger and your XLITE should turn on. You can connect to it using VESC Tool, connecting through BLE. It may show up as either VESC BLE UART. Go to the ENNOID BMS tab, and look at the General Tab. The Number of cells tab should include the amount of batteries that are in series. For example, if you have an 18S2P battery, that value would be 18. For an 20S2P, it would be 20. Your Number of Temperature Sensors would be the number of temperature sensors plugged into your battery. Pack Capacity would be the amp-hour rating of your battery.
Write those values and you should be good to go!